The stool was built based off plan from here : https://www.diypete.com/how-to-make-bar-stools/. But was modified to use 2×2 instead of 2×4 since the lumber available here is not soft wood. The table design was also based off a guide on the internet but I could no longer find the link to the page.

I build a jig to do crosscut with my circular saw

stock was cut and assembled

lumber was chosen and jointed for the seat board

1/2 inch rounding

all sides are rounded for comfortable handling

Stained with mahogany read

Finished with polyurethane

table top is jointed

Table leg is heavy

table top finished, 1/4 inch rounding

All done