Xenon output comparison (with halogen)

Before

After

Output comparison

Comparison between 55W halogen with 35W HID, HID is more efficient because most energy is converted to light while halogen radiates a lot of heat

Low beam before (halogen)

Low beam after (HID)

High beam before (2X 55W halogen)

High beam after (bi-xenon shutter)

Done

All in all I’m okay with the result, not very happy with the high beam and I’m blaming the cheap bulb for that. Suspecting that the arc chamber is skewed causing the light to be off center. Will try to get new proper bulbs and keep these as spares. Probably going for 55W ballast next time for crazy output. Hope this would help anybody looking for a guide or help.

Quad projector electrical works

A simple circuit was designed to handle the existing control input from the car. When flashing with the low beam off, activate the halogen and its projector shutter. But when low beam is on, high beam or flash activates the bi-xenon shutter. Schematic as follows

Circuit produced

Another set of relay is used to convert the 3 wire AL solenoid to 2 wire input. We need to enable the strong pull solenoid momentarily before then activating the weak solenoid to hold the shutter down. Schematic follows, the capacitor would allow short energization of relay until it is fully charged, resistor is to discharge the capacitor

The relay set

Capacitor for HID to solve flickering problem

Capacitor for angel eyes, also for flickering problem